Under Wireless Mode select “Access Point”.Add the following, and click on “Change” bottom right.MAC address, physical connection state, bandwidth usage, connection quality and connection speed. On this screen you will see all your active connections to your device, firmware version, The next screen that appears is the Main Screen. In this guide I will be using Complaince Test for Country please select your appropaite region. Next you will need to enter in the default Username and Password “ubnt” for both. Click on Advanced and then on Proceed to.Quickstart guide from ubiquiti to get the device connected to your PC. Note: You either need to be in the same IP address range or you would need to change your IP configuration on your PC to static Please follow the The factory default IP address for the device is 192.168.1.20 and the subnet mask is 255.255.255.0 (/24) open internet explorer and connect to 192.168.1.20 if you are using one of the latest firmware versions you will be redirected to https and you will see privacy error page You can use this setup to create a link between office buildings up to 50miles (depending on the device) Here. I will be focusing on the selected part of the diagram below for this guide using Nanostation, Bullets, AirBridge, Nanobeam, NanoBridge to name a few. This guide can be used on the following Ubiquiti AirMAX devices. This article is a step by step guide on how to create a basic PTP link using Ubiquiti airOS devices.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |